How Should An Outdoor Fences Be Installed



How should an outdoor Fences be installed

Outdoor Fencess can be found in the balcony, park, bridge, shopping mall, square and so on. Outdoor fencing is also mainly used for safety protection, so the installation of such safety guardrails should be subject to certain specifications. How should an outdoor Fences be installed? When installing outdoor barriers, we need to know the installation steps and methods of outdoor fencing:
Outdoor fencing
1. Preparation for outdoor Fences construction
1. Review the drawings, find out the required materials, the form and height of the Fences, and the embedded parts to see if there are any special requirements
2, the corresponding drawings to see the Fences construction surface, including the civil whether it was already finished surface (determine the height of the Fences to do), field Fences size segmentation whether is the same as the drawing segmentation.
Ii. Paint construction
1. Structural treatment, grinding of metal components with sharp edges, grinding round of chamfering, removal of spatter, welding and smoothing of weld holes.
2. Surface treatment, remove the material that is harmful to the coating, especially the oxide coating, rust, soluble salt, oil and water, etc., which are the causes of the rusting.
3, the ground processing, after the surface processing complete, use the grind sandpaper to clean up the ground powder and then grind the sand paper, the first time the atomic ash to the grinding light to the second time the atomic ash to grind the light. The surface roughness should be paid attention to the surface roughness during the primary treatment. The surface roughness increases the surface of the coating layer and increases the adhesion of the coating layer to the substrate. The roughness can't be too large, otherwise the coating thickness can be caused by the insufficient thickness of the coating at the peak, causing the early erosion, and trapping the bubble in the deep pit to become the root of the coating bubbling.
Paint the base coat, paint the paint, fix the color, and fix the atomic dust. Spray paint a second time to repair the atomic ash polish.
Outdoor Fences
1. Finish the paint, paint the first coat of paint, and grind the water sandpaper, until the third time.
2. The size of the glass must be measured by four sides. The rectangle must be measured in opposite angles. Glass dimensions cannot be full size must be based on site scale. The size of the hole glass is not only the four sides, but also the outer edge of the glass to the hole center distance.

3. The installation of glass, determine that the installation of the construction has no influence on the glass installation. To clean up the surface of the installation, you can't make hard objects like pebbles. The glass pads must be used for special glass pads, which can't be replaced by hard objects like hard resin. Glass that is installed with glass, can't tighten the glass nail, too tight will make the glass crack. Pay attention to the finished product protection when installing glass.

4. When the glass needs to be fixed with glue, it must be noted that neutral glue must be used. The construction of glue must be full and must not have a concave drum.

Iii. Product protection

1. The finished product protection of decorative surface shall be covered before painting.

The protection of the finished product protection of the Fences.